-
I have a 6 pack controller that I have gone over the wiring multiple times. Had a friend also look at it. to confirm. I seem to have everything hooked up correctly. I can Enable and disable the moto…
-
- [ ] #88
- [x] #74 Printhead page typos
- [ ] #26
- [ ] #46 Could be used for Hot end / goliath
- [x] #90
- [x] #91
- [ ] #39 Belt routing / motor designation
---
https://www.youtube.com/wa…
-
-
I work with an raspi pi 4 and astroberry. Up to now I am very satisfied. But two problems are left:
1. I cannot connect the raspi with my router speedport of german telecom.
2. I have an spectrograp…
-
Buenas, queriamos saber si este modulo para controlar el motor paso a paso esta bien... https://articulo.mercadolibre.com.ar/MLA-728430892-modulo-a4988-driver-pololu-3d-ramps-cnc-arduino-cdisipador-_J…
-
Hello , did somebody tried to use this library as motion controller mode.
Meaning that sending speed and destination via SPI and chip has full control motor ?
thanks a lot.
-
I am getting reverse lookup error when calibrating. FYI, I am driving a geared yaw mechanism with the stepper and the MKS-SERVO42C magnetic sensor is placed just above the yaw axis, not on stepper.
…
-
I would like to use the ports, but I don't know what their pins are, I looked in the schematic and I didn't find.
 and found in the code (TMCStepper.cpp) the following possible values:
```c
void TMCStepper::blank_time(uint8_t value) {
switch (value) {
case 16…
-
We are a group of students who are trying to replicate the construction of this robotic arm and we have encountered a problem that we are not able to solve.
We are using the code provided in this git…