-
at first i thought it might be EMI so i made sure to get a shielded usb cable with ferrites at both ends
no dice
so i disconnected my entire machine and plugged it into my desktop pc and tried again…
-
I am working on the movement code in dda.c and I discovered that the rampup_steps value (and rampdown) was completely wrong. After working my way back to where it was calculated, I got stuck on the ca…
-
### Checklist [README]
- [X] Device is not undervolted nor overclocked
- [X] Device is using the [latest drivers](https://github.com/IGCIT/Intel-GPU-Community-Issue-Tracker-IGCIT/wiki/Intel-driver-up…
-
Quite a few 3D printers today support true arc commands which have some worthwhile benefits. These GCODE commands (`G03` and `G03`) produce smooth arcs with significantly less GCODE which eliminates f…
-
I am building a 3D printer that uses a pressurized pump instead of a stepper extruder to print material. Consequently I have no need of the fourth-axis A G-Code commands as there is no filament nor st…
-
I have a suggestion for the endless spool function in happy hare on the ercf.
Rather than unload the filament once a runout has been detected, I recommend that it instead passes a specified amount of…
-
Currently, the whole area is specified and scanned in one resolution.
Using the nudging feature, it should be possible to do 0.2° steps, but this would take a huge amount of time to complete.
No…
-
Hi, would it be possible to add a feature to the probing part of the sender. One that would probe along one axis at two points in order to determine the angle if the stock is not exactly squared to th…
-
When streaming a dummy to a real display, it is possible to move the mouse over to the stream target display itself. This might be confusing as it looks like the mouse is on the dummy desktop while in…
-
Hi Guys,
I am trying to get my 4-Axis SPI CNC controller board V1.3 board to function with a set of TMC5161 drivers I bought from Bigtreetech and some Nema23 motors (2.80A/phase) for my CNC project…