-
I opened KControls_D12.dproj, set "Windows 64-bit (Modern)" target, and tried to compile but I got this error:
`[dcc64 Fatal Error] KControls_D12.dpk(33): E2202 Required package 'dclstd' not foun…
-
Dear Anne,
Further testing of 'ChaoShared' showed errors difficult to understand:
`test
-
Hi is possible convert this library to use d11,d12,d13 Spi pins?
miso a19
mosi a16
sck a17
ss a18
I am totaly newbie in Arm.
-
The two dialogs for opening forms and units are not saving the width size of the columns when I increase it, close it and open it, it does not take the last width I entered.
-
### Cura Version
5.4.0
### Operating System
windows 11
### Printer
Wanaho D12 230
### Name abnormal settings
Non
### Describe model location
non
### Describe your model
non , oui ,oui
### …
-
Just a heads up, the numbering on the D00, D6, D12, and D8 are not in the standard position.
This was pointed out to me after showing some photos of masters I had finished and sure enough, comparing…
-
- [x] Checked for duplicates
### Describe the bug
`cling` running in emacs eshell and comint will result in input string to be repeated severals times before the output is printed.
```
[…
-
The transient voltage suppressors (TVS), IC's CR4 and CR5 (schematic sht. 23, D12 and H12) are not connected to +3.3V (net XP3R3V_FPGA), thus offer no protection for the '125 buffers against positive …
-
It appears thermistor reference voltage is OVREF set by zener D12
However, thermistor circuits create resistor divider on VCC
If I read this right, a slight change in vcc will cause temperature to re…
-
It would be great to be able to use this excellent OPC library in something newer than D6 (latest mentioned in the docs) or D7 (where I have successfully got it working).
I've had no success in cu…