-
Add a fuel gauge (or spec a charging IC with that feature) to report the estimated battery level of the device. This will allow the Tympan to close an SD recording before a power failure. Note that …
-
Hi,
I created a `quantity` for `Sv` (Sievert) and I got `gray`, this is not done for other non-SI units. See the attached code:
```
from pint import UnitRegistry
UR = UnitRegistry()
q = UR.Qu…
-
Use this form to register a new ontology with the OBO Foundry. Please read the instructions provided here:
http://obofoundry.org/docs/NewOntologyRegistrationInstructions.html
## Ontology title
Ra…
-
Heya @mchamberland,
Were you keen on testing the whole Wlutz arc method? What vendor/model Linac do you have?
If you are, I can step you through the current installation process. I am working on…
-
-
Once something fails one test is there a way to make all other tests N/A for that dosimeter. Once something fails in calibration we just stop testing it, so we may not have any data for some of the t…
-
As I understood what we want, I am going to implement the 'Quick Setup Example' from Datasheet Page 8-9. This will be:
- 'High Sensitivity' Mode
- 1 Second measurement window
- Ref Osc 50kHz
@an…
-
You need to close the web site down and reopen to get a new model of dosimeter to show up in the calibration drop down box. I'm not sure this is an issue or not, but I though I could try use this.
-
Is it possible to alphabetize the customers and the dosimeter models in the drop down box on the calibration form?
-
If there are no failed dosimeters, and you click failure reports in the reports section, the screen just goes blank and you can't go anywhere. If I hit refresh in the browser it goes back to normal.…