-
### The problem
I've been successfully using a Dallas onewire temperature sensor on my ESP8266 boards for quite a while, but after upgrading from 2024.5.x to 2024.6.x (beta) and updating the config…
-
Hello ,
my software get sensor info by type on Serial to return
A = Get MLX90614 Ambiant
B = Get MLX90614 Ir Temp
C = Get BMP388 Temp
D = Get BMP388 Pressure
…
-
When I run the DS18S20 in normal mode, everything works as expected with the 4k7 Ohm. When I try to run it in parasitic mode, the library does not detect the sensor. But when I manually ask for the po…
-
> Supported and tested Hardware
>
> embedded real life test
> setup: run test-example, use ds9490-master, arduino 1.8.3, Windows 10 and the board-library named in the brackets
Hi,
…
-
Ich bekomme Werte in 0,5 grad Schritten geliefert. Kann man es feiner auch noch machen? 0,1 wäre super
-
I have been trying to get DS18B20 1-Wire temperature sensors to work with Raspberry Pi 2, with the 1-Wire Pi Plus adapter card installed, as in article https://www.abelectronics.co.uk/p/60/1-wire-pi-p…
-
Gdy w konfigu WWW urządzenia ustawimy >1 czujników DS18b20 - można kliknąć w nazwę i wchodzi się w zapisywanie DSów wg znalezionego numeru MAC
Jest to bardzo fajne, bo od razu pokazuje MAC (czyli - …
-
This might only be a small thing, but I noticed that the function `getResolution()` returns a value of 12 bits if a DS18S20 is selected. However, according to the [datasheet](https://datasheets.maximi…
-
### The problem
I have a group of four old DS18B20 sensors. These sensors are over seven years old. All this time they worked under a proprietary device on the ATMega-32.
These sensors are still op…
-
Hi there,
I am trying to run an Arduino sketch which works fine on an ESP32 on my Pi Pico. The device unfortunately crashes when trying to do this.
The sketch contains the following code, and is…