-
Hi,
Great work you have done so far. I also wanted to try to create a gateway myself then I stumbled on your project. I have gone through the LoRaGW userspace C code and currently they use the Ublo…
-
Hello, I'm having difficulty getting an 128x64 ABC panel to function without artifacts/glitches. I've also been testing a chain of 4 64x32 displays and after identifying a number of issues I finally …
-
I had some trouble compiling the firmware last week and finally got it to work so I wanted to share the steps I took. First though -> I would suggest using the released pre-compiled versions if you do…
-
Hi
First of all thank you again for the amazing work that you made with this library.
So i have a setup with 8 64x32 panels (as the picture) and i see some occasional flickering, meaning multip…
-
Hi there, I see this is very active in responses and don’t know where else to post my question so here’s hoping:
I have installed and am running your examples very successfully, but I’ve run into …
-
I have a panel setup where my display is mirrored onto a 2nd display, so I use ribbon cables to plug the 2nd set of panels as output of the first ones.
I don't get or want a wider display, I just use…
-
Hello,
I recently purchased 5 of these modules from ebay ([https://www.ebay.de/itm/285579711444](https://www.ebay.de/itm/285579711444)) and I can only get one half of the display to light up when I…
-
I want to add 2.5Gb ethernet card to my chromebox. I added it and it doesn't work.
Some information about system:
firmware-util.sh output:
```
** Device: Asus Chromebox 3 / CN65 (TEEMO)
** …
-
-
For the next generation PCB, we're looking at switching away from the Atmega328p, since it is becoming too small for future additions (see also #2). This issue summarizes some of our previous consider…