-
Using the following command causes scryer to print to screen (as expected), but then immediately exits back to the command line without an error.
```
$ scryer-prolog plc01.pl
?- json(J), flowmete…
-
The switch control on my Sedna VA4220ZB disappeared after updating Home Assistant to 2024.8.0. I've attempted to re-pair it both with and without the custom quirk, and in both cases I no longer have a…
mtwo updated
2 months ago
-
Hi All!
Thank you so much for the support in the past! This cute little device is serving me well, and watering my trees happily as we speak ❤️🥑🌳
I have a further use case: When my water storage…
-
### Did you test the latest `bugfix-2.1.x` code?
No, but I will test it now!
### Bug Description
WITH SYNTAX G2/G3 X Y Z I J F THE AXIS DO MOVE BUT VERY SLOWLY
This potential bug was first repor…
-
## Overview
The purpose of this ticket is to add timestamp information for submissions to allow the tracking of the following:
- Submission Set Queue to Completion Time
- Submission Set Job Dur…
-
Salve. Sotto consiglio di una persona ho deciso di provare questo firmware. Però, compilandolo con Arduino ottengo i seguenti errori:
In file included from Configuration_Store.cpp:39:
/base.h:14:2…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Some LCD pages are not in the language file, such as "Configuration > Debug > Endstop Test". …
-
### System Health details
-
### Checklist
- [X] I have enabled debug logging for my installation.
- [X] I have filled out the issue template to the best of my ability.
- [X] This issue only contain…
-
Hi,
I'm using mk4duo 4.3.2. I have a bltouch clone. I set it up as blotuch sensor (couse if not, then it leaves the tip out when moving the next calibration point).
Sometimes when measuring a ca…
-
Hi, Using 4.3.9 Configured with the online configurator. Have 2 nozzles set up by adding the following to configuration_overall.h
#define SWITCHING_NOZZLE
#if ENABLED(SWITCHING_NOZZLE)
#de…