-
I am pretty new to this stuff so I hope I'm not making a stupid mistake.
I used URH to receive a 868.3Mhz signal from a remote. I don't have any insights about the content, I just want to send it to …
-
Hello, I wanna ask some question about module and debug lib. I use debug library as you say and results are "0". I check my connections and my module is working properly 2 days ago.
Are my module …
-
Hello everyone!
I'm facing a RF test for my project with ESP32 to get a national standard certification by ANATEL (Brazil).
I need to do a few configurations on my device, for each test.
I re…
-
In the paper, it is introduced that RML22 includes 10 modulation types, while in open source code, there are 11 types, and the RML dataset downloaded directly is also 11 types. So we want to know if t…
-
I ran into the receive/sent freeze and found that it should be fixed in rev. 2.5.1
I have the 2.5.1 installed but it still hangs when I switch from Rx to Tx Mode
I had a running receiver and added t…
-
Hello!
I'm trying to decode GFSK pulse code in 169.4375MHz wmbus narrow band. Have a several captures and the demodulated outputs in RTL_433 don't seems that have a valid bits.
```
C:\Programes\Rad…
xjols updated
5 months ago
-
Hi there ,
i use a LR1121 , and in my design i do not use SKY13588-460LF Switch ,
as an MCU i use STM32L4
I can talk to LR1121 , i can update the Radio firmware , i can send all commands , h…
-
This model is using Volantex radio with 5 channel receiver EAR403. Is it possible to bind multimodule to this receiver? The V761 protocol does not seem to work on 4-CH mode, maybe this EAR403 is a dif…
-
**Is your feature request related to a problem? Please describe.**
I'd like to use RadioLib to receive GFSK modulated messages with RFM69 and RFM95 modules.
Per its spec sheets, the modules should s…
-
We are busy developing a new Sigfox device using the LR1110. Uplink works without issue. Downlink does not work. I can see that the message is received by the LR1110 and the EP-LIB goes through all th…