-
Heater control assumes celsius and fails with Fahrenheit device.
-
I see that the 'control' section allows for HVAC, Presets, Fan, and Swing
would it be possible to include modes for water heaters? Unsure if it would be name 'operations_list' ?
Example (Rheem Ec…
-
In trying to restart the satp2 cryomech compressor from ocsweb, we got error note that the state 'None' is not valid. I believe we need to give it 'on' or 'off' state in ocsweb.
In addition (note …
-
**Describe the problem you have/What new integration you would like**
Water pump pressure control by pressure sensor connected to A/D converter and use similar card on HA dashboard than the bang …
-
Adding this here to not forget, the H2 and O2 tank systems had control modules so that both tanks had to be at a low pressure condition to engage the fans/heaters in AUTO.
For missions with 3 H2 an…
-
Apex has a few pre-built controls that you could explicitly support, for instance a temperature control. From the "config":
```
{
name: "Heater_2_4",
icon: "Thermometer",
ctype: "Heater",
log:…
-
### Feedback
In the `Service water_heater.set_temperature` table, it seems the usage of `{% term integration %}` does not play well.
It seems to result in `[[Learn more]](https://www.home-assist…
reedy updated
3 months ago
-
### Device
_No response_
### Version
_No response_
### Question
After our last discussion around mqtt and LWT, I need to be 100% certain a devices is online.
My use-case, I am controlling a h…
-
As a user i would like ibex to indicate if the eurotherm is in automatic or manual heating mode (as in the switch on hardware front panel). If the hardware is in manual mode then everything looks fin…
-
As currently implemented, the `joey` board has six 3x7 heating zones, with upper and lower zones on the left, in the middle, and the right, but there are only three heaters, with each heater controlli…