-
When using e.g. VR32 for connecting one eBUS to another and providing access to a single device in the second bus on a dedicated address on the first bus, the communication timing is no longer specifi…
-
After DST last night, my clock shows the correct time but the wrong UTC offset (still shows UTC-8 when it is now UTC-7).
-
More food for thoughts...
As more sensors added to espurna, it looks like espurna is getting much more than a simple wifi relay with a power meter option....
So it may got to the point of adding a…
-
## Where?
3D magnet driver (which is an LvDCOM over a manufacturer VI)
## How?
Due to the failure of a temperature controller, the kit is being physically rewired to (re-)use one of the exist…
-
Can you please tell me how the pins of ESP32 are mapped to driver outputs, heaters and fans i.e in schematic I can see them connected through STC15W408AS controller which is communicating with esp32 u…
-
### Feature request
Regarding a floor heating here the legislation (and hygienic regulations) says the **floor should never overheat above let's say 27 Celsius**. If you have an **electrical floor he…
-
I would like to have the EEP D2-01-0C running. It is used to control electrical heaters in France and measure their energy consumption.
Both Nodon and Avidsen have implemented this EEP profile.
H…
-
-
**Is your feature request related to a problem? Please describe.**
Improve DHW heating control logic. Now it's little bit chaotic
**Describe the solution you'd like**
DHW temperature set point s…
-
Before I've installed bltouch everything worked perfectly after I've installed it the head moved 10mm up before resuming and print in the air.
I think safe_z_home is the problem not sure I've used in…