-
Hi, (in German below)
first of all thank you @the78mole and @jensgraef for making this result possible!
I now have the existing sensors in operation and it works perfectly.
I will try to incr…
-
I found out that rather than just dividing those values by 2, they seem to have the purpose to display 0.5 step temperatures as a float value.
This should be the case for
heating_circuit_1_…
-
Hi,
first of all: This is awesome - All of you guys participating and really printing boards and software for a 15+years heating-control. I absolutely adore this.
I got the board from Daniel and…
-
Currently we have a binary switch to toggle warm water heating between "auto" and "night".
This toggle actually supports "auto", "night" and "day".
Replace this switch by an "select" component to …
-
Currently the writer class only supports one telegram at a time.
This should be changed to allow multiple pending write commands.
See https://github.com/the78mole/esphome_components/issues/4#issue…
-
Hi @the78mole. I would like to use your board but i need to make small modiffication. I would like to add there 1-wire iface for sensors to the boiler and end it by terminals: https://de.farnell.com/…
-
Be able to process a single bit of a byte of a specific telegram and use that for a sensor -> read "Betriebswerte" of HK1, WW and so on.
See https://github.com/the78mole/esphome_components/issues/4…
-
heating_circuit_1_mixer_position and heating_circuit_2_mixer_position have the device_class=DEVICE_CLASS_TEMPERATURE.
I'am not sure which device_class would be appropriate, or if it could be omitted …
-
Arduino Uno dirket per USB Kabel am Raspberry Pi angebunden.
433MHZ Empfänger XD-RF-5V
Empfangspin ist am Pin 2 (D2) des Arduino Uno angeschlossen.
Automatisches Device wurde in Fhem angelegt…