-
Von Google Code: https://code.google.com/p/part-db/issues/detail?id=14
Bilderupload durch einen universellen Dateiupload ersetzen (keine Einschränkungen bezüglich Dateityp), damit neben Bildern auch …
-
Storing these four 32-bit values for almost nothing always bugged me, so let's take the plunge and remove them entirely.
These values were introduced together with lookahead. However, lookahead cod…
-
Akku:
Ist es wirklich ein (gehört) 3S Akku (=11.1V) ? -> NEIN das kann nicht sein.
Wieviel mA/h Stunden hat der Akku. ?
Welche Maße hat der Akku. ?
ERF R003 v2.0 CISECO
http://www.ebay.…
-
Is there a expressly preferred way to power the multigeiger?
The ESP kit has a two-wire cable (red/black) which seems to mount to the surface bracket, and it has a USB connector. On the main PCB ar…
-
### Describe the bug
When attempting to send a CAN-FD message with a payload larger than 8 bytes using 'slcan' bustype connected to a CANABLE device, the message appears to be truncated or not sent a…
-
I have a request for a feature for LED testing. Sometimes I'd like to determine the voltage to apply to an LED to get a current of e.g. 5, 10, 15 or 20 mA so it would be nice to have a function where …
-
I have compiled the firmware k 1.50 for TC1, atmage324pa 16Mhz.
The compilation works, but there is no display.
When I press a button, the screen lights up (white), then goes out a few seconds later…
-
# Equiva key-ble Smart Lock Integration with Home Assistant using keyble and keyble-mqtt
Hey there! Are you struggeling to integrate your eqiva smart lock into your smart home and control it using …
-
Hi,
I had quite some difficulty getting this to work on a Raspberry Pi using `rppal`. I finally figured out it was because `FullDuplex` is too slow since it sends every byte individually. Since the `…
-
**Describe the problem you have/What new integration you would like**
I have a energy meter installed in my house that exposes its data via M-Bus. I would like to see support for reading values o…
poear updated
1 month ago