-
There is an occasional race condition that causes a dropped packet. The problem can be seen in the graph below.
![Screen Shot 2021-05-19 at 9 17 46 AM](https://user-images.githubusercontent.com/16…
-
`setFCU()` and `setFCD` accept 16bits values.
Why are 32bits values not supported?
Thanks!
-
I was testing LoraSendAndReceive sketch with MKR 1300 WAN as node and a PyCom LoPy as "nano gateway" with The Things Network.
Pycom "nanogateway" / TTN can occur in "join accept" downlink timing prob…
-
Hardware: Arduino MKR1310
Firmware: 1.1.9
Library: LoRa.h 0.7.2 from https://github.com/sandeepmistry/arduino-LoRa
##Abstract
MKR1310 scrambles data instead of transmitting it unaltered.
### …
ghost updated
3 years ago
-
This is probably more a question than a problem.
I have on several occasions noticed that when I attempt to sent a packet, I receive an error with the call to modem.endpacket(). I prepare and se…
-
Hi @sandeepmistry
It is device and library support Class C?
thanks
-
hello, I'm not receiving the data on arduino with LoRa with the same code, i could see serial monitor for sender like: Sending packet 0 Sending packet 1 but for reciever monitor output is like…
-
We have had four reports of this error on the forum in the last two days. The usual trick of clearing out the data folder and trying again didn't work for any of them. One of the users, Cheetor, provi…
-
When running (MKRWANFWUpdate_standalone.ino), I am getting this error:
```text
WARNING: library MKRWAN_v2 claims to run on samd, mbed architecture(s) and may be incompatible with your current boar…
-
Hi.
I am using MKRWAN with the standard arduino IoT library. My device is quite on the edge regarding signal quality, and found out that joinOTAA uses a quite weak data rate ("bandwidth": 125000, "…