-
List of bugs/improvements to make for MPPT Rev 2
-
hi, i can use
mpp-info-pub -d /dev/hidraw0 -q 127.0.0.1 -c QPIGS
and mosquito receive datas
but if i try to start service i have:
/usr/bin/python3 /usr/local/bin/mpp-solar-service -c /etc/mpp-…
-
So I am seeing a lot of CRC NOK as well as a few CRC OK. Which makes me think that I must have things wired up correctly, maybe? But I am just getting everything reported as 0.0 or off.
Could this …
-
## Description
The SW direct components exported by FV3 have odd "blips" over the course of a day. This is shown by setting mediator history files to write the instantaneous fields every time throu…
-
Hi thank you for this great project.
i just want to clarify the hardware part little bit. you mentioned
```
The hardware part is simple esp8266 module with RS232 level converter attached to the…
-
Hi,
I'm also am developing MPPT based on this project.
I've already designed my own PCB incorporating some of the hardware changes You mention in your notes (like low side shunt current sense an…
-
Is there any possibility to perfom continuous polling and sending to MQTT?
By continuous polling I'm referring the phone app working mode.
The BLE setup is extremely slow and prone to error (someti…
-
```
# docker run --rm --device=/dev/hidraw1 jblance/mppsolar:latest mpp-solar -p /dev/hidraw1 -c QPIWS
Traceback (most recent call last):
File "/usr/local/bin/mpp-solar", line 8, in
sys.exi…
a-mkh updated
1 month ago
-
It would be pretty cool if there were an option to replace NULL values with a predefined one such as 0 in the config file. One of the csv files I have to deal with is full of nulls instead of zeros an…
-
I am trying to interface from an Arduino Uno (Master) with the EPS 2.0 board (Slave) via I2C. I have flashed the firmware, located on the spacelab-ufsc/eps2 GitHub page, to the EPS 2.0 MCU using the p…