-
hello Timo, another long post from me, apologies!
Testing and finalising configuration on my 2 new engine blackboxes running ESP32S and MCP2562. Each Device sends:
PGN127493, gearbox oil pressur…
-
Timo,
tried to use a NodeMCU ESP-32S I recently bought.
connected it to an MCP2551 exactly as I have it running on a teensy 3.5 and 3.6
compiled properly (had a bit of an issue uploading the code…
-
Receiving data to OpenPlotter running on a RPI3 with an actisense NGT feeding data in. Everything else working, and NMEA2k data appears to be correctly arriving in Signalk - all other apps and OpenCP…
guyht updated
6 years ago
-
Hi,
Maybe creating a `meta` layer only for the [CANBOAT](https://github.com/canboat/canboat) would be interesting.
I am looking into it and found out that Yocto does support `Makefile` [Link](ht…
-
Hi Thomas
perhaps a very beginer question: I changed NMEA port 1 to 4800Bd and integrated KBox WiFi into my network.
Then I compiled and uploaded the firmware. All runs fine, but after Reset KBox sh…
-
hello Timo,
Have managed to collect a lot of boards, chips and trying various combinations.
Using a MEGA + NRem canbus shield everything works fine.
Using a teensy 3.2 or 3.5 + MCP2551 again al…
-
Hi,
I was about to start a fresh install of OpenPlotter on a UDOO board but I realized that **the installation doc is outdated** ("Obsolete, working on a new version!" written on top of doc since 28t…
ghost updated
7 years ago