-
Hi, can someone give me datails about exact version of working 300w?
It seems that OpenTherm is not activated on mine :-(
Is it necessary to have the control panel connected on OT? Actually i have n…
-
Hi and thanks for the great FW.
I use the firmware on a Nodosvop v2 with a PIC16F88 on PIC FW 5.0.1 and MCU FW 0.9.5+4eb7d24 (30-05-2022).
It's configured on a MQTT server that I run in a container …
-
Hi All,
Last weekend I received the OTGW from Nodoshop and have it running with a Chronotherm IV Thermostat and Intergas HR 36/30 stable since then (firmware version 0.9.2+e9c35e9 (08-01-2022)). Wh…
-
### The problem
Since this week (but may be much longer since I didn't use it for long until I create a new automation), controlling the Domestic Hot Water Mode of my OTGW is no longer working. I can…
-
Since updating to 0.10.0 the hostname I configure in settings is not actually used, it seems to be "esp-" with the last few digits of the MAC address added.
I have tried resetting all settings to d…
-
Hello,
I flashed Wemos D1 mini and after flash I have only this on serial output: "wrong chip id 0xf4fc"
Where can be problem? I flashed it with this command: "C:\Users\ropo\AppData\Local\Ardui…
-
I'm trying to build with arduino-cli, which works fine after installing some libs which are not added as git submodules yet.
After building there is a /tmp/arduino-sketch-* folder, which contains the…
-
Hi.
I have an old PCB as described at https://otgw.tclcode.com/ (I bought from Node Shop few years ago).
Right now I'm using a remote connection with otmonitor an a ESP8266 with Ser2Net (ESP Eas…
-
Hi Robert,
In regards to your PM, I'm posting the same question I also posted on the domoticaforum.eu here.
For original post: [https://www.domoticaforum.eu/viewtopic.php?f=75&t=13381&sid=132eba…
-
### Feedback
Can the default TCP port be mentioned in the 'configuration / path' section:
According to this topic : https://www.domoticaforum.eu/viewtopic.php?t=13438&sid=f0c7225c9f97a60dd771088…