-
Hello, what did you use for the terminal pins and where can I buy them? They don't appear on the BOM.
-
Hi Dear Wolle!
Is it possible to allocate a separate pin for ESP32 S3 on which a high level would appear in sleep mode. I would like to use it to cut off the power supply to the audio power amplifier…
-
### Plugin Description
would be nice to pin some servers that we might be admins or the ones we use almost all the time. after pinning them they would be at the very top at the list with a pin mark
…
-
### mantine-react-table version
v2
### react & react-dom versions
v18
### Describe the bug and the steps to reproduce it
https://v2.mantine-react-table.com/docs/examples/sticky-row-pin…
-
Similar what we do for libstdc++, provide a mechanism to depend on openssl at a version compatible with whatever is used by Julia.
-
If this thing fails, it reports the failure to the screen which, of course, gets lost unless we capture it.
This makes running the pinning session impossible unless one is watching it.
-
Guys
I picked up a tildagon and a hexpansion board at EMF 2024 but unfortunately the hexpansion will not power up, I have traced this back to there being no ident pin to ground connection but am st…
-
Hi, ich versuche pin_mapping für Fusion Board mit einem SDM-Zähler über RS485 + JK-BMS + 1x Victron einzurichten.
Ich bin total verwirrt was die Pinbeschreibung angeht.
Da steht
https://github.co…
-
Hi everybody,
I tried to figure out which pins I from my ESP32-S3-Wroom-1 I have to connect to which pin of my ESP32-C6-Wroom 1 controller. Despite having found the "Access-point-pinouts" page, I ha…
-
In my project i need to monitor cts/dsr pins and should have exchange with device by complex protocol. So i use tokio-codec, but it's takes ownership of port itself and i can't read pin states. is it …