-
Just recently I was made aware that extruder backpressure actually influences the effective e-steps value, which causes slight under-/overextrusion. Backpressue varies due to a number of factors, incl…
-
About two hours into a long print of the Vanderbilt Mansion (Marlin at 115200 baud, Sanguinololu 1.3a, Replicatorg, Slic3r-created gcode, http://www.thingiverse.com/thing:10485), the extruder and plat…
-
Bonjour,
Mon MKS-TFT70 est bien allumé , carte wifi fonctionne, mais, aucune commandes est exploitable, pourtant la câble et les connections sont bien vérifiés
1/ quelles sont les paramètre dans "co…
-
using ";" for comments renders them white instead of green. I had to switch back to the original nc-gcode version to get them green again.
Is there a setting I am missing in the preview version?
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Using TMC2209 drivers on an Octopus motherboard with a full graphics smart controller. …
-
I currently have inherited a Melzi with an atmega644.
Would like to use 1.0.5 Arduino software to fix the firmware.
Currently this only seems to support the newer after the support for Arduino v1 l…
-
Marlin firmware actually has a command
M165: Set multiple mix weights
A[factor] Mix factor for extruder stepper 1
B[factor] Mix factor for extruder stepper 2
C[factor] Mix factor fo…
-
The /cam_1.mjpg does *not* live stream in browsers if build with WXP_COMPAT (but same live stream plays fine in ff/chrome using old mjpg-streamer). This bug is in the original mjpg-streamer-experimen…
-
Does Reprap (repetier) firmware in Arduino execute the sent commands from pc, slicer program, raspberry pi, octorpint, etc.... line by line or does it wait? How many lines or commands does it take unt…
-
Repetier (for sure since 1.0.0, probably even before) and other firmwares support recovering from fatal errors by issuing M999 command:
* http://reprap.org/wiki/G-code#M999:_Restart_after_being_sto…
depau updated
6 years ago