-
Using RatOS-v2.1.0-RC2, Prusa MK3S does not generate configuration properly.
It is missing definitions for the display and filament sensor. It also assumes, regardless of having selected no accelerom…
-
The 5-min offset for data retrieval, combined with only hourly updates causes RPi-Monitor to interpolate the Status values, which makes decoding the flags very difficult.
Not sure how long the EBA…
-
**Describe the bug**
the core voltage the firmware picks for a given frequency depends on what range of frequencies you can select
with the default config, manually cycling thru the 4 available fr…
-
Hello,
i was wondering how i can get a higher sample rate when reading a sensor. I use a Raspberry Pi with 8 gig RAM. CPU is set at 1200 Mhz. I am using the ADC-device to capture sound, so i need at …
-
**Describe the bug**
When booting upstream kernel v5.12.10, even with `vc4-kms-v3d-pi4` overlay applied, vc4 still fails to probe the HDMI.
The board is CM4, thus not sure if it's related to the d…
-
**Describe the bug**
"Firmware transaction timeout" message and gst-launch hang on a Pi 4B 4GB when running `gst-launch-1.0 playbin uri=https://some.domain/720p25-h264-aac.m3u8`
**To reproduce**
…
-
On Tue, Sep 26, 2017, at 05:17, SFN - M.Fischer wrote:
> I wanted to delete the GESTURES.TXT or rename it but the rPi is
> shutting down right after powering up. Is that a known bug? It even
…
-
**Describe the bug**
RPi 3B is excessively overheating on a non trivial workload. CPU throttling is unhelpful as the core voltage does not scale down with ~~core clock~~ arm_freq.
**To reproduce**…
-
I found that rpi-fbcp is having some performance issues, so I replaced the one bundled in your image with the fbcp-ili9341 one found here: https://github.com/juj/fbcp-ili9341
The difference is nigh…
-
Hello,
Thank's for your code !
I have no display on my TM1638.
Test python 2.7 :
```
root@raspberrypi(rw):/opt/rpi-TM1638# python setup.py install
running install
running bdist_egg
ru…