-
I don't get any data over the GPIO interface from seatalk 1
Signalk version 1.39.0
Rpi 4
OpenPlotter install
GeDaD MCS board with the following connected devices:
Raymarine instruments via N…
-
Thanks to some good advice I finally managed to solve the "SERIAL_9N1" problem, the software compiled successfully and runs fine. The SEATALK communication works (at least according to the oscilloscop…
-
Hello,
I successfully have the script running! The only issue I'm running into is when I first turn the SP200A on, if the esp32 is the first device to connect to its wifi, data doesn't seem to flow…
-
Hi Bernd,
I compiled and enabled your fantastic plugin. I don't get the autopilot status and also don't see any outgoing msgs generated by the plugin..
I connected the PC with an Actisense NGW-1…
-
Hello, Using this project, would it be posible to read the seatalk data using the usb and defining se serial comunicaction (nm0183) in openplotter/signalK¿??
-
You use this in `GetAutopilotCompasCourse() `to produce the course received from the autopilot in $STALK 84,:
`CompassValue = (int)((parameter[0] & 0x0c) >> 2) * 90 + parameter[1] / 2)`
Using Thom…
-
I set a premade route active, autopilot_raymarine and then started Marco Bergman's ais-simulation.exe
https://github.com/marcobergman/ais_simulation
and finally got things right and recorded a sessi…
-
Do you want the plugin to be named
"raymarine_autopilot_pi"
"autopilot_raymarine_pi"
"autopilotRM_pi"?
obviously your choice, but I need to know before I make the 3 cloudsmith repositories.
htt…
-
Hi Bernd,
I installed your Plugin on android and it seems to be working overall, except for the settings dialog which cannot be used because it's too big and cannot be scrolled to the bottom where …
-
Bernd,
Sorry if this sounds very stupid, but I am not an OPENCPN user and I need to find out how to install this to assist someone.
First, is this different from the AutoTrackRaymarine plugin that …