-
@satakagi @kou029w
PiZero版のチュートリアルサイトを WIMC+ の各地のメンターや学校関係者の方も見る(使用する)機会が増えてきた事もあり、より使い勝手を良くするための UI 変更をメインとしたリニューアルの作業をしたいと思います。
今の構想はサイドメニューを付けて各情報のアクセスを容易にする変更を考えていて、内容変更までは考えていませんが、リニューアル作業…
-
I'm trying to use this library in an ESP32 project in platformIO IDE but don't understand how to do it.
I read the value of Temperature & humidity from a sensor and want to pass it to Two Input regis…
-
We need to verify the SHT30 driver that we've written and make sure it works with actual hardware or in Renode (in hardware is best). Basically we can just create a small test application that will ju…
-
Hi, after flashed 3.7 firmware to the new device, I'm able to read values in TelinkMiFlasher web page and ESPHome & Home Assistant. Unfortunately, the display always shows the same values (25.4 C and …
-
Hallo zusammen,
es gab schon 2 Issues, wo der BME 280 keine Daten mehr sendet. Meiner sendet zwar kontinuierlich, ab und zu sendet er jedoch wirre Werte. Im Anhang ein Screenshot.
Manchmal werde…
-
### The problem
SHT31 module fails to initialize after updating to 2024.4.0. I reverted to 2024.3.2 and verified it works there.
### Which version of ESPHome has the issue?
24.4.0
### What type o…
-
Sorry @tannewt I've not managed to get a good debug output as it goes straight to safemode, but when a debug build I didn't see that it just stalled and serial eventually disconnected.
I was testin…
tyeth updated
3 months ago
-
As a first step, we should ensure that it is possible to dump the stock firmware of the device.
-
Hi!
I make firmware with 2 sensors SHT30 and ds18b20
```
Board type: CC2530
Device type: Router
Output pins:
P06: Output 1, Temperature sensor (I2C), Pull-up (Address (dec): 68, Type: SHT30)…
-
This is a zigbee temperature and humidity sensor. Look the same as TH03Z. The sensor used is SHT30 sensor.
I tried to flash this sensor with the firmware from TS0201_TZ3000, but it doesn’t show anyth…