-
Laptop connection on the USB port kills the engine if Tunerstudio or another serial monitor is not running. The outputs will stay off until TS is launched. I’ve tried all variations of the reset con…
-
if you setup as basic distributor and 8 cyl. it only outputs ignition pulses on ign 1, for a few seconds, then goes to outputting 4 pulses in a row, then skips 4 pulses then repeats continuously. play…
-
Allow o2 feedback based on boost load and look up of afr table as opposed to just currently tps. Will aid turbo spool up by running consistent leaner mixture, but suggest possible max psi in o2/afr eg…
-
As title. March 740 firmware
-
Hi. I'm trying to learn more about engine management by making a plug-and-play ECU for my silver-top 4AGE. On the software side, I was hoping to use the original spark and fuel maps from a black-top a…
-
In file included from speeduino/globals.h:108,
from speeduino/acc_mc33810.h:5,
from speeduino/acc_mc33810.cpp:1:
speeduino/board_stm32_official.h: In function 'voi…
-
Hello,
I am working with a 2.1 Board for M50b25tu
I am having no start issue with no RPM values on Tach or in Tunerstudio.
I am getting 5 Volts at 1 and 2 pins on the crank plug(from the ECU) and…
-
Firmware 202207.1 and master as of 10/31/2022 have a bug where Launch Control feature isn't setting the clutch input pin to use internal pullup resistor. I also tested with WMI tank empty input and it…
-
Iv purchased my first speeduino to use on my is300 (2JZ VVTI) to which i'm very excited about (so much potential for my self with learning and the platform itself) the UA4C is a capable board, and wit…
-
Per forum: https://speeduino.com/forum/viewtopic.php?f=12&t=2048
Feature request:
A simple form of afr safety, so you dont blow your engine if a pump or an injector fails.
Setup would be somethi…