-
following error happens when i try to use autotune with fysetc-42HC40-204A-300N84:
`TMC 'stepper_z' reports error: DRV_STATUS: 40150010 s2vsa=1(ShortToSupply_A!) cs_actual=21 stealth=1`
the motors…
-
Hi all, I've been attempting to configure two 2209 stepper drivers sharing a single UART on an STM32G0B1RE based board (using the stm32duino framework) and have come across an issue initialising both …
-
Hi,
My setup with an Adafruit M4-expressboard with a bigtree TMC2209 works when I use serial1.
However I need the serial1 fo a GPS shield, so I created Serial2 by using sercom code.
This created s…
-
Will be great to get it for 12v version,
-
### The problem
I'm setting up a stepper component and I have run into an issue where the motor won't turn any faster, but isn't having any torque issues and is otherwise running as normal.
The …
-
pbbob updated
6 years ago
-
Good day (o;
Got me some BTT SKR Pico boards for testing several CNC setups.
Compiled in VSCode (git pull from today) on macOS as the web builder doesn't work on macOS Safari and some settings …
-
I had to interface with a TB6560 stepper motor driver board for a project and have written code (using but not integrated with gpiozero) for controlling it. It would be fairly simple for me to create…
-
Not an issue, but I wanted to pass along the circuit and picture of the board I made for driving 5V inputs on larger stepper drivers. Some of the drivers I use have optocoupler circuits built into the…
109JB updated
4 years ago
-
Hi Everyone,
After closing #2, a number of people have continued to have layer shift issues under various circumstances. I thought that maybe this was due to acceleration or jerk settings, but usin…