-
Using this library, I have observed issues and device hangs on receiving mac commands from the network server, for example receiving something similar to this: https://lorawan-packet-decoder-0ta6puini…
-
Hi
I have a project on a custom STM32L0 board where i want to deepsleep and be able to wake up by serial.
I uploaded the SerialDeepSleep example and it works as expected.
Since i want a led h…
-
Per our twitter conversation:
///
Hi. It's lot of things that needs to be changed when you choose another timer. My guess is that you need the TIM2 to some specific task/PWM.
Please start the Githu…
-
Hello, I need some help setting up LittleFS.
I'm programming a custom OS for embedded devices and I'm trying to integrate little fs in it for flash filesystem management, but somehow I can't get to m…
-
While debugging an application which is mis-behaving, I have discovered the need to determine the free memory available in real-time to see if something is going wrong.
For Arduino there is the lib…
-
Hi,
I'm using your RPi image for low cost gateway. It boots fine and I would like to test communication with a end device.
I bought some [ST LoRa demo boards](http://www.st.com/en/evaluation-tool…
-
If I send a lorawan message with an empty payload, even if I specify a port, the message is sent on port 0. This is invalid, as port 0 is reserved for mac commands.
![Screenshot from 2021-03-03 08-…
-
Hi
Is it working ?
SPI1.begin();
-
MJS2020 has an accurate RTC that stays running during sleep, so allows accurate timing of measurements. By feeding the GPS time into the RTC, this also allows nodes to have an absolute sense of time.
…
-
I have some problems getting it working, but maybe I am just using it wrong.
I have a STM32F411 Nucleo board, so MPU should be supported to my understanding.
I set it up like this:
~~~rust
#[e…
ctron updated
3 years ago