-
Read in data from temperature sensor and send to server
-
The unique address of DS18B20 should not have changed, but when running again after a power outage, the address changed and caused data reading errors. The main issues are as follows:
1. The addres…
-
When an inverter is not available the temperature reading is -100°C, which throws the graphs out of scale.
It should rather be left "unavailable", so that home assistant won't display data points.
-
The BTT SKR v1.4 Turbo board running Marlin 2.0 has been working great for about 2 months. Now, I suddenly get a E1 Heater error for the hotend. On further investigation, the temperature reading on …
-
The spec sheet says it can read in 0.5C resolution, but the libraries only support whole numbers (integers).
Could this be updated?
-
```
Hi,
I'm using the trunk version of wfrog code
(https://code.google.com/p/wfrog/source/browse/trunk/wfdriver/station/vantagepro
2.py) on OpenWRT OS for logging on a DB values from my Davis Vantage…
-
If Temperature is outside 0-300 °C range stop heater and reset ADC
same if pressure outside -10-100 kPa
-
Hi,
I am trying to make sense of MG100 GW and having a problem where battery voltage is rubbish. This seems to be because it is compensated using temperature measured from LIS2DH and that temperatu…
-
For some reason temperature readings for device indoor and outdoor is always the same. Indoor 22 degrees outdoor 10 degrees.
Any way to fix this?
-
```
Hi,
I'm using the trunk version of wfrog code
(https://code.google.com/p/wfrog/source/browse/trunk/wfdriver/station/vantagepro
2.py) on OpenWRT OS for logging on a DB values from my Davis Vantage…