-
Hi.
I use Attiny3226 on megatinycore. I want to 16 pwm output from PA4 pin. But I am not success it?
Please take sample sets.
Thanks.
-
Hello,
I have the following setup : Arduino ver. 2.2.1 / megaTinyCore ver. 2.68. ATtiny402 on breadboard without any other IC, 2 pull-up resistors with value 1K (I do not have higher value) to pin 4 …
-
Hi,
I'm using and attiny 804, and I need to wake up from sleep to power a couple of LED strips (yes, you may have seen a similar code elsewhere). The code is this:
```
#include
#include
#includ…
-
Hi,
I've just found your great project! Would it be possible to add other chips (looking for Attiny1616 debugger currently)?
Is this project based on reverse engineering the debug protocol or is…
-
@Spence,
Just found out that your great DxCore is available for PlatformIO!! Fantastic!
Is there a change you will make the megaTinyCore also available (in the near future) for PlatformIO??
H…
-
Hello!
Is it possible to add Wurkkos TS11 / TS25 support? They seem to share the same firmware, code `0715`. I found the config file [here](http://bazaar.launchpad.net/~gabe/flashlight-firmware/and…
-
Hi!
It seems that the URL
_http://drazzy.com/package_drazzy.com_index.json_
is down. I'm getting an error whenever I start the IDE.
Thanks
-
I'm not sure if this is possible, but I was wondering if these usb dongles can be used as linux gpio pins via the libgpiod device manager.
So they can show up as:
`/dev/gpiochipN` where N is the c…
-
### Summary
The lint `cast_possible_wrap` is triggered by a conversion from `u8` to `isize`.
The displayed message is:
casting `u8` to `isize` may wrap around the value on targets with 32-b…
-
hi, i would like to drive 4 PWM led drivers with an attiny 84 MCU, i noticed i can not get all channels to output at same frequency, the datasheet suggest a prescaler of zero can be applied to both ti…