-
[The manual](https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-V1.0/blob/master/BIGTREETECH_Octopus_EN_updated_0719.pdf) shows how to set UART and SPI modes, but offers no clue how one would go about…
-
TMC2130 support for Marlin 2.0 bugsfix has been successfully compiled to run with ESP32. A native ESP32 pin needs to be used for the CS pin, for example, GPIO21 (SDA) or GPIO22 (SCL).
TMC2208 and T…
-
### Description
I've read the configuration file and i saw that the driver for both u20 and u30 pro is the same (A4988) while the u30 pro have mounted the TMC2208 driver.
There is a complete com…
-
Just updated from one Allot's previous versions.
Steppers are noisy and it's printing at about half speed with this build. I'm thinking steppers are different.
My Sapphire Pro uses an MKS Robi…
-
I got my board today. For testing, i connected one stepper (Z). According to the manual i removed all jumpers from the STEP/DIR headers and set them on the UART headers. But i always get a "TMC CONNEC…
-
Add Linear Advance on LCD setting on latest firmware
Please maybe you can ADD linear Advance on latest firmware so that it is easy to adjust on LCD Display..
Thank you
-
Don't use this version on the Ender 5 pro. the z-axis steps are 2x on ender 5 pro (it has a different z-axis screw) so this version of the firmware will only move up 1/2 the correct amount, which of …
-
Hi Isaac! I'm planning on building one of these, but I'm having trouble with some of the part specifications. Could you be more descriptive about the motors, for example? Are they uni/bi-polar, what i…
-
I installed the BTT SKR 1.4 Turbo and have been able to print for a while. Recently the extruder would stop mid print. X, Y and Z would keep going and heating was kept on. After stopping print extrude…
-
Buena noche, tengo una placa skr v1.3, en los ejes XYZ tengo tmc2130spi y en el extrusor tengo un tmc2208uart. El problema es que configuro en VSCODE, en la placa coloco los jumpers en los pines que s…