-
I just bought the skr v1.3 with tmc2209 drivers. I downloaded the firmware adjust everything I needed and every time i compile it I get this all these errors.
FileNotFoundError: [Errno 2] No such f…
-
Notes for a post about what changes to make day-one to a new Sovol SV08
1. Board fan (https://github.com/adepssimius/everything-sovol-sv08?tab=readme-ov-file#quieter-mainboard-fan)
Comment out `[…
-
hi.
I am trying to install tmc2209 into E1 socket on nano-s board and connect via uart (4th pin on tmc2209 (PDN) as TX to PC14 via 1k resistor and as RX directly to PC15:
```
Marlin/src/pins/stm32…
-
### Bug Description
After installing the new firmware (DGUS_TMC_v1.5.3) as well as TMC2209 drivers in my Mega X Pro (2nd gen w/ Trigorilla 0.0.2) following the tutorial in this repo my stepper moto…
-
Hello I have a problem again. The board arrived and I got it working. I did calibrate the Z endstop and the probe everything was working fine. I did change the fan connection to PB2-24v 2x controller …
-
I'm unsure what is causing it, but I can only now successfully home my machine if I disable tmc_autotune for the X and Y motors. This used to work prior to updating today. Here's the relevant parts of…
-
following error happens when i try to use autotune with fysetc-42HC40-204A-300N84:
`TMC 'stepper_z' reports error: DRV_STATUS: 40150010 s2vsa=1(ShortToSupply_A!) cs_actual=21 stealth=1`
the motors…
-
Hello, followed the instructions exactly, Voron starts up but motors do not move and message on LCD "Steppers OFF".
Is this a bug or a setting that needs to be updated in the config ??
Thank you…
-
Greetings! thanks for this lib. i've used https://github.com/janelia-arduino/TMC2209/ successfully over one wire UART and got stallguard working.
# problem
i'm using an esp32 and _rust_, so wan…
-
printer: Anycubic I3 Mega-S (upgraded)
board: 8 bit trigorilla 1.0
I'm running a mixed (tmc2209/A4988) stepper driver configuration (A4988 on extruder). and i am very confused about configuring th…