-
[klippy.log](https://github.com/KevinOConnor/klipper/files/2975524/klippy.log)
I am looking to life change the current of my extruders, but it just gives back
```
Send: SET_TMC_CURRENT STEPPER=e…
-
Hi,
The log is attached below.
I am at the early stages of running Klipper on Duet3d/Ender3 ( still haven't done all the work on the config.cfg). I run into a deadlock. There is a need to do "FI…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Hi, I'm using Azteeg X5 GT control board with Viki2 LCD, I have an issue with the marlin firm…
-
I'm writing a config based off of yours. looks like you designate A4988 drivers in config.h. not sure if this has changed, but the kp3s now ships with removable TMC2225. was this the case when you dra…
-
Hi All
I have not been able to get my TMC2130 steppers running since trying to move over to Klipper.
After many hours I just had to make sure that I am not dealing with a hardware/wiring issue s…
-
Invalid params
-
This issue is a notice of my intent to make the next Klipper release (v0.7.0). My rough plan is to make the release around mid December (~20181214), with a feature freeze starting the end of this mont…
-
I have been through the list of Pins at the top of the Duet-Duex config file and am unable to see any reference to temps for the MCU and Steppers, as I would like to view them on MainSail.
RRF uses '…
-
Hello,
FYI: no SD card is inserted in Duet2.
erase was triggered and reset pushed before flashing
I cannot connect to duet2 Wifi.
I flashed the firmware to the MCU succesfully using SAM3/SAM4 (…
-
@KevinOConnor Hi I am just getting started with Klipper and so far it is great but the only problem is the lack of the CoreYX kinematics.
I did look at `./klipper/klippy/kinematics/corexy.py` but i h…