-
Dexcom is in the process of replacing G4 Platinum transmitters with the new Bluetooth LE-enabled G5 Mobile transmitters.
While I have not yet updated my Share receiver to support the new G5 Mobile sy…
-
**Describe the bug**
Hi
I have tried to use dumpmem command on Raspberry Pi 4b, but the Internalblue CLI hang up after `Received Data: complete` message exists.
**Hardware and operating system*…
-
I want to have multiple U1 devices attached for kismet to consume, but be able to distinguish them regardless of the order they're attached/plugged in. After discussing in the Discord server, a "open…
-
Hello,
I was hoping to see if I could help add support for the HT1 series of sensorpush devices as I noticed they're not part of the existing support. I've seen vague references to "unable to deco…
-
I’m a little stuck w/ the interactive motor. The angle based motor movement works kinda ok, but if I move forward and backward by say 40 degrees, the movement isn’t exact (also it is a move-by, not a …
-
Hi all,
I've found a bug which has given me a lot of headache for a couple of days. The problem is as follows:
In lib\blue_hydra\command.rb the following line is present, starting from 18:
``…
-
Hi!
I followed your guides with no problem at all until I try to actually sniff packets, moment in which I get nothing.
### My config at `pyclient/config.py`
```python
# Raccoon BLE Sniffer …
-
I have noticed that a few devices that show up in the command line output are never written to the database. Does anyone know why or what I could check to troubleshoot? Thank you.
-
-
I can't seem to get any devices to show up in Sparrow for bluetooth.
If I run bluetoothctl with scan on I get a stream of devices found.
[bluetooth]# scan on
Discovery started
[CHG] Controlle…