-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
`MPCTEMP` and `CR10_STOCKDISPLAY` give this error
env: GD32F103RC_voxelab_aquila
``…
-
I must have missed a step or an update broke this process. The display now turns on and shows the stock graphics with the OEM buttons and everything. Before it would just sit at the Sovol startup sc…
-
### Did you test the latest release build?
Yes, and the problem still exists.
### Bug Description
When i start to load filament it load just a bit (I think it's calibrated on a direct extruder) but…
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### OrcaSlicer Version
2.0.0
### Operating System (OS)
Linux
### OS Version
Ubuntu
### Additional sys…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Not sure exactly how it came about, I'll try to reproduce it.
So out of nowhere I ge…
-
### Did you test the latest release build?
No, but I will try it!
### Bug Description
I had a go at installing Klipper and couldn't get it to work so I'm back for good !! I hope you guys keep going…
-
### Did you test the latest release build?
Yes, and the problem still exists.
### Bug Description
Actual extruder steps is doubled with Input Shaping (probably) enabled. Even with manual E ax…
-
### Did you test the latest release build?
Yes, and the problem still exists.
### Bug Description
Had no issue installing the firmware and used the Voxelab Red DWIN set for the screen. Everything w…
-
### Did you test the latest release build?
Yes, and the problem still exists.
### Bug Description
Ok, I downloaded what I THINK is the correct version and Fashed it.
"Aquila_GD32_BLT-5x5-NoPro-MPC…
-
### Did you test the latest release build?
Yes, and the problem still exists.
### Bug Description
December Rev 1 release. It appears that for the ProUI UBL version, the Mesh Fade now defaults to 2,…
vw72 updated
4 months ago