-
We have a somewhat similar HW setup as on the pyboard D-series:
- STM32F7
- one spi bank is connected via softspi bitbang
- the other spi bank is connected via HW SPI
- both are 128MBits in size…
hoihu updated
2 months ago
-
**Description**
Hi, Following the instructions given here:
https://github.com/ghaerr/elks/blob/master/BUILD.md
When I select the option to build a ROM, the compile fails with an error about und…
-
I tried to run 3.5 inch LCD with driver ili9488 in 4-line SPI mode on fbtft overlay, but this driver (ili9488) does not support RGB565 mode in 4 line SPI. If driver init with RGB666, then i`m take wro…
-
Thanks
-
I'm not sure if this should be logged here or in [the test suite repo](https://github.com/riscv-software-src/riscv-tests/issues) - but I'll log it here for now. :-)
I have built the latest toolchai…
-
### Description
Hello,
In the last couple of days I followed the getting started guide to simulate the opentitan design on Verilator.
I followed the instructions of https://opentitan.org/book/doc…
-
In GitLab by @michael.dreher42 on Jul 17, 2020, 05:29
I already started to implement this, but I don't have the full information. Please see attached Libreoffice spreadsheet for the structure of the …
-
Hi.
I just connected the hx711 model to the P5 header but are unable to read any data.
I just try with 2 different sensor from 2 different manufacturer, but all time say "no data to consider".
Also …
-
How to drive it ? It is 26 output only pin of 341B/A/F, described as #INI "Initialize the printer, active low, connect to INIT" in datasheet in print port mode or as RST# "Reset output, active low" in…
-
**Describe the bug**
A clear and concise description of what the bug is.
The gyroscope attitude is reversed
**To Reproduce**
Steps to reproduce the behavior:
I used the firmware version 0.4.3, af…