-
I recived a new testing prototype from RADXA with the print RA028_X1.0 (thanks @hipboi )
It's an 4 bay M.2 NVMe Hat that supports 2230, 2242, 2260,2280 NVMe's and is powered by a USB C port at 12 vo…
-
### Describe the bug
This issue is meant to be a common place to discuss the changes required for I2S support on Pi 5. Existing issues that cover this area are https://github.com/raspberrypi/linux/…
-
Will you be adding RPI5 Support?
thanks
-
In NixOS 21.05, the ``hardware.deviceTree.base`` option can no longer be used. After trying to do some research, I figured out that the lines that I was using successfully:
```
hardware.deviceTre…
-
Hi team,
I followed the steps described here to install on RAK2247 :
https://learn.pi-supply.com/make/iot-lora-gateway-sd-card-image-setup/
I'm blocked in step 5, cant reach http://iotloragateway…
-
hello, i cant activate enc28j60 on raspberry pi 0 w using raspbian buster lite,
>pi@raspberrypi:~ $ dmesg | grep -e spi0.0 -e eth
[ 20.570373] enc28j60 spi0.0: enc28j60 Ethernet driver 1.02 loa…
-
![hat-geekworm-x1011-4-drive-nvme](https://github.com/geerlingguy/raspberry-pi-pcie-devices/assets/481677/fa351f78-7ee5-4941-8d0b-56743085f53a)
Geekworm's X1011 is a 4-drive M.2 NVMe SSD carrier wh…
-
Hallo,
ich habe deine Software nochmal auf einer neuen Raspi Installation aufgesetzt.
Das Skript starte ich von Hand, den service habe ich erst gar nicht enabled.
Wenn ich nun truma_service al…
-
![radxa-x4](https://github.com/user-attachments/assets/dfa684a7-0862-4a0c-8941-85d825d78713)
## Basic information
- Board URL (official): https://radxa.com/products/x/x4 ([docs](https://docs.r…
-
I have spent some time figuring out why my ABCDE Q3F32v4.1 Qiang-Li 64x64 panel does not work correctly with the Adafruit Matrix Hat. I had not tried it direct wire.
After much time I have come up …