-
Hi.
I've just finished the mechanical and electrical build for a large OX-CNC from Makerstore.
We are running arduino uno, GRBL0.0j, CNC shield v3.0 with TB6600 stepper drivers and adapter cables to…
-
Hi
my arduino client can't connect to the public broker test.mosquitto.com.
The Serial Monitor output: Connecting to MQTT... failed state : -2
Here is the code, where is the problem?I don't find i…
-
I'm using Arduino MKRGSM 1400 and MKR GPS shield connected via I2C.
If the I2C is not wired (GPS shield is not connected at all) when calling GPS.begin(); it ends up calling (twice) _wire->end(); …
-
I have the Boteltics 7000A shield, it is connected how you instructed through the indestructible setup. It is stacked on an Arduino Uno. Using a registered Hologram Sim card. Lipo battery is 3.7V 2000…
-
This is intended to track bugs found by the peripheral selftest, so that the bugs are not only found but eventually also fixed :)
- [x] Incorrect Arduino Mapping on Nucleo64 boards (see https://git…
-
```
I am working on a servo controller using an TLC9540.
Problem is that I am not able to turn the servos more than +- 60 degrees using
the standard program for controlling servo's with an TLC9540. (…
-
```
I am working on a servo controller using an TLC9540.
Problem is that I am not able to turn the servos more than +- 60 degrees using
the standard program for controlling servo's with an TLC9540. (…
-
Hey guys, I'm having a problem that I can't figure out. I tested successfully the "mini" shield with an Arduino Nano. Almost no problem at all, just sometimes the keyboard doesn't initialize, but I'm …
-
Amit and I discussed using this solution for the same sensors that are on an evk board.
The evk should show existence of sensor. (ss_* is Shield board; bb_* is base board)
This actually shows the…
-
```
- Car is Alfa Romeo Giulietta 2010 1.4 MA
- OS: win 7 SP1 x32
- can shield is with MCP2516 and is working with Arduino Uno r3.
- Arduino and Can shield is working on car
-Sniffer car ECU --------…