-
I can compile it with the supplied UBL config, and my Bilinear + Lin Advance, but combined gives an error concerning lines 463 and 464 in `creality_dwin.cpp`
https://gist.github.com/nullstalgia/986…
-
### Description
Z-offset display box doesn't show numbers below -0.01
### Steps to Reproduce
The following assumes you are using the original CR-6 bed.
1. Go to the leveling screen.
2. Pl…
-
### Description
When removing and re-inserting the MicroSD card, the firmware does not re-read the card. It shows the same files as before the card was ejected.
### Steps to Reproduce
…
-
### Description
One of the biggest advantages of this firmware is when printing from a host like OctoPrint the DWIN display switches to the print screen and displays the same informations as when p…
-
[Printer Sounds.m4a.zip](https://github.com/InsanityAutomation/Marlin/files/4434575/Printer.Sounds.m4a.zip)
Steps to Reproduce
1. Get CrealityDwin2.0_Bleeding
2. Configure for CR10XMax
3. …
-
First of all, thanks for putting this together. One of the biggest hangups I had with Klipper is the lack of machine control, and your updates helped get my touchscreen working with it.
However, …
-
### Description
Current HAL code has support I2C EEPROM but if connected chip has size less then 32Kb (4KB) it can't be accessed. This is due the fact that smaller chips use only one byte addressing…
-
Hi all. I am trying to connect the board to this printer, used different configs for Marlin (Bigtreetech and Marlin), but everywhere I run into a problem.
If I specify board "default_envs = STM32F103…
-
### Bug Description
In the latest bugfix, I have activated the ABL bed leveling in the configuration files. When I try to activate ABL in the G28-G29-M500 sequence, the printer gets restarted e…
-
### Bug Description
I am trying to get my Ender3 v2 working with a bltoutch and currently get a "Needs a programmable LCD controller" or playing around getting Boot_screen needs graphical displ…
h8dyt updated
3 years ago