-
Hello,
I am running ubuntu 18.04 LTS with gnuradio installed using pybombs I did manage to have gr-fosphor running inside the gnuradio.
I did installed qspectrumanalyzer with command: sudo pyth…
-
Hi there,
I'm trying to run kalibrate-bladeRF on my x40, i tried to run it over GSM850 and GSM900 but still no result shown, even i tried with -m. here are some info relate with my stuff
./kal -…
-
This results in wrong pseudoranges calculated and, as a result, incorrect PVT.
Channels, that have locked to a wrong correlation peak are showing too low C/N0 in GNSS-SDR Monitor. Sometimes that chan…
-
When running the software I get the following error messages:
jonathan@ezra:~$ conda activate
(base) jonathan@ezra:~$ srt_runner.py --config_dir=/home/jonathan/srt-py/config
{'SOFTWARE': 'Small R…
-
RPi4b8gb - Installed librpix and SoapySDR_rpitx, rebooted per the instructions. Module is in correct directory.
Fired up GNU Radio Companion and cannot find any modules for rpitx.
At a command …
-
Great summary!
You can add some more info:
The mt7612u(n) doesn't support DFS, but it can use that channels with different reg domain.
The multi ap mode (guest ap mode) works too.
-
Hello, I am working to install gr-gsm and receiving this error every install attempt
CMake Error at CMakeLists.txt:150 (message):
GnuRadio Runtime required to compile gr-gsm
I have manually…
-
### What happened?
I am using the Web updater to upgrade from v2.0.0 to v2.0.2. This is what I am seeing:
mkdir /FIRMWARE
Error calling delete_file: 8 exists
ch> fclose
no open file
ch> fopen /F…
-
### What happened?
"Hardware does not appear to have been manufactured by **Great Scott Gadgets**" Message after Flashing **Mayhem Firmware**
After successfully flashing;
Already referred to [#1…
-
Here's an error I got when trying to use this plugin.
```
See the end of this message for details on invoking
just-in-time (JIT) debugging instead of this dialog box.
************** Exception…