-
Hi I tried to connect 4 **TMC5160** in daisy chain. However I could not get the motor moving. There seems to be a **SPI problem** with the TMC5160s. I have also _grounded_ the CLK pin
However I'm …
-
Anyone with skr mini e3 and ABL kit can make a guide what is needed to change in the firmware?
I try follow the marlin but when put g29 after g28 the printer halted
-
Good morning,
i've made a new Marlin 2.0.5.3 Firmware for my Ender 3 and got a problem with the homing where i cant get into it.
Bigtreetech SKR 1.4 Turbo
TMC 2209
BL Touch
I got sensorless…
-
Hi, I just have this tft (v3.0) with a skr pro 1.1.
The babystep function doesn't work when trying o use it in touch mode : increasing or decreasing the value don't make the bed up or down !!!
If I …
-
Hi!
Just tried to flash a Manta M8P (V2.0) with Katapult / Klipper. It uses a STM32H723 controller.
Compiling and flashing Katapult was no big deal. And since I enabled the Status LED I can see…
-
Hello. First of all congratulations for your great work with this printer. I have obtained very good results, and it is a luxury to have information like this at our disposal for those of us who do no…
-
Hi, Uart is not possible to get working with the latest image.
Is there anyway to get this working again?
-
When i am printing more then 1 model, always after a couple of layers, the error message pops up,
"Too long extrusion prevented".
And the most funny thing,
After that error, for some weird reason…
-
Hi !
I have a 3D printer with dual extruder and a 2 nozzle hot-end.
I am using BigTree Tech SKR PRO V1.2 mother Board and BTT TFT 3.5.
I am printing with 2 nozzles perfectly fine.
I thought of con…
-
Kann sein, dass ich hier noch was falsch mache, da ich mich als Neuer noch nicht richtig auskenne.
Ich entschuldige mich im voraus.
Ich habe einen BIQU-B1, der nicht funktioniert.
Weil die Y Achs…