-
Can I change the font used in fw? I would like to make it more minimal. If it's possible, then how to do this? And if it's not, will it be possible in the future?
-
### Description
Hi,
When I want to check or uncheck "Filament sensor" or "Power-loss recovery", I cant see the checkbox like I'm seeing in JSTECH video.
When I long press in "Filament sensor" f…
-
First of all, thanks for putting this together. One of the biggest hangups I had with Klipper is the lack of machine control, and your updates helped get my touchscreen working with it.
However, …
-
### Description
One of the biggest advantages of this firmware is when printing from a host like OctoPrint the DWIN display switches to the print screen and displays the same informations as when p…
-
### Description
When removing and re-inserting the MicroSD card, the firmware does not re-read the card. It shows the same files as before the card was ejected.
### Steps to Reproduce
…
-
[Printer Sounds.m4a.zip](https://github.com/InsanityAutomation/Marlin/files/4434575/Printer.Sounds.m4a.zip)
Steps to Reproduce
1. Get CrealityDwin2.0_Bleeding
2. Configure for CR10XMax
3. …
-
### Description
Current HAL code has support I2C EEPROM but if connected chip has size less then 32Kb (4KB) it can't be accessed. This is due the fact that smaller chips use only one byte addressing…
-
Hi all. I am trying to connect the board to this printer, used different configs for Marlin (Bigtreetech and Marlin), but everywhere I run into a problem.
If I specify board "default_envs = STM32F103…
-
### Bug Description
In the latest bugfix, I have activated the ABL bed leveling in the configuration files. When I try to activate ABL in the G28-G29-M500 sequence, the printer gets restarted e…
-
### Description
Hi Everyone,
I didn't use a precompiled firmware, i compiled my own based on Jyers/Marlin Branch (sorry, i'm new to github, not sure about exact terms to use). i used the…