-
### The problem
When receiving an RF Remote with the Dooya protocol, ESPHome detects it with ID `0x00b2c5a9`. However, both a Flipper Zero and a HackRF Portapack with the Mayhem firmware read the s…
-
**Hardware**
Raspberry Pi 3b+
- RAM: 1GB
- SDR: local RTL-SDR
**Software**
- Operating System: Raspbian 12(bookworm) - 64bit
- SDRPP nightly build - Oct 23, 2024
I don't know if it helps …
-
I believe that the decoding using SF12 is not successful. I am testing the code using RN2483 (waspmote module from libelium) and SX1276 with an arduino. Is there any known problem?
-
Hi all, just paid yesterday at 13:56 to ss7.dev $1000 (got all the proof), nothing happened.
No answer, sent 3-4 emails to them and nobody came back.
In case you stumble upon this website, beware I…
-
I'm new to the GNSS world. I have successfully run gnss-sdr with HackRF and obtained the correct position. Additionally, I have been able to record data using GNU Radio Companion and HackRF, and then …
-
When calling "sudo rfcat -r" it sometimes works fine, but usually it gives me either
"Error claimning usb interface:USBError(16, u'Resource busy')
or (more common)
Error in resetup():USBError(110…
-
Implement decimation and interpolation on the Cortex-M4 to support sample rates lower than 8 Msps over USB. It probably isn't practical to support arbitrary decimation/interpolation rates, but half, …
-
I tried the framesync64_example and everything worked Ok. So, I tired to actually use it to transmit some data. It says that it has a spectral efficiency of 0.8000 b/s/Hz which seems to mean with a 1…
-
Hi
I am trying to get the triggers working in the channel scope, but it does not seem to function as expected.
I have set trace length to a minimum to detect a single pulse. With a sample rate of …
-
Should be pretty easy to take some values (freq range, gain, etc) from a new web page, stop services, run the scan, show the png file right there on the page.