-
```
1. Software SPI is working well, but to slow (0,75FPS) for my application
2. I'm not able to init parallel mode
What is the expected output? What do you see instead?
-I expect the same Output as …
-
```
1. Software SPI is working well, but to slow (0,75FPS) for my application
2. I'm not able to init parallel mode
What is the expected output? What do you see instead?
-I expect the same Output as …
-
```
1. Software SPI is working well, but to slow (0,75FPS) for my application
2. I'm not able to init parallel mode
What is the expected output? What do you see instead?
-I expect the same Output as …
-
I just installed the plugin on my WordPress site today and sent a webmention by publishing [this post](http://www.epiphanydigest.com/2014/10/18/new-social-tool/).
The target of my webmention was [thi…
-
```
1. Software SPI is working well, but to slow (0,75FPS) for my application
2. I'm not able to init parallel mode
What is the expected output? What do you see instead?
-I expect the same Output as …
-
```
1. Software SPI is working well, but to slow (0,75FPS) for my application
2. I'm not able to init parallel mode
What is the expected output? What do you see instead?
-I expect the same Output as …
-
I cannot run the default example which uses the GPIO pin 13 for the onboard LED:
``` javascript
var mraa = require('mraa'); //require mraa
console.log('MRAA Version: ' + mraa.getVersion()); //write t…
-
This creates programs that do not make sense.
-
LED on PIN13 should turn on when the sensor is reading, and stay on until values has been written into SD card
-
Just trying to run my code on the Teensy 3.0 with Teensyduino 1.20 RC6 and Arduino 1.0.6. It works perfectly in 24Mhz mode but in 48Mhz and 76Mhz I get multicolored blinking confetti on my leds, so pr…