-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
@onox wrote:
> I think we need to stop rotating the spinner (that thing to which the propellers are attached to) when the engine is crashed. The propellers correctly stop rotating, but the spinner do…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…