-
Is there a way to implement an option to select "kill after file from SD is finished" via LCD.
Background is, that I quite often start a long print which ends somewhen at night. Most of the time I f…
-
I installed v1.1 yesterday and that went without a hitch, however, when I try and connect some host software (I've tried Repetier Host and S3D), the whole screen looks like what is shown in the [video…
-
Since i upgraded from RCBugFix to 1.1.3 bugFix i experience random layer shifts on every print.
![img_20170609_184609](https://user-images.githubusercontent.com/20832276/26986638-a9d935d2-4d48-11e7-8…
-
Marlin v1.1.0 RC3 Rambo with GLCD (REPRAP DISCOUNT FULL GRAPHIC SMART CONTROLLER with SD card) using S3D slicer.
Using the left hand hot end/extruder which in my case is tool1 (right hand is tool0) t…
-
**Describe the bug**
Not sure if this is a bug or I'm missing some external plugin, but the "extruded filament" display always shows "0.0m" for me.
**To Reproduce**
Steps to reproduce the behavio…
-
Hello I finally was able to upgrade to RC8 via using an older adurino software as suggested 1.6.8. The only issue I see is that the part cooling fan (Not the heater fan is not working. I did try…
-
I run a Rambo with Marlin RC6 Bugfix
I also use simplify3d as my controller/slicer
Windows 10 64bit PC
Often I turn on my printer (Makerfarm i3v 12") and tell it to start to preheat for ABS
then afte…
-
Hello,
I have problem with manual mesh bed levelling. After I put M420 S1 in GCODE bed levelling start working (offset from bed is good), but it was start printing out of bed. I placed part on the…
-
I am trying to use RCBugFix up to commit eeb4902 (May 2nd) and appear to have an issue that I am not sure is configuration or something else.
Bed heating shows the proper message of 'Bed Heating..…
-
### The problem
I leveled my bed, set a proper hot adjustment for Tool 0 fine, but when I attempted to offset Tool 1 it was too close to the bed. I went into advanced controls and hit the 0.04 adjust…