-
I've set up my BMP180 module, plugged it into J3, but it isn't being recognized. wondering if it was broken, I stuck my multimeter into the board, and it's receiving 5V. the wiki mentions to power t…
-
This has happened twice in a row now. I've left my set up on my bench running overnight with the RY835AI. Throughout the evening I'd run the Stratux GPS/AHRS page and found reasonable values. By morni…
-
Hi RedSnake64
I used a Yun to do some mesurements with official openwrt but it crash after 1 or 2 weeks.
I use now the Linino version it's more stable but the wifi disconnect sometime, to avoid this I…
PBE93 updated
8 years ago
-
While initialising a board with a BMP180 baro connected, some BMP180's can pass the MS5611 CRC test resulting in the false detection of an MS5611 baro.
Alternative firmware test for a BMP085/BMP180 b…
-
When using ESPlorer to compile read-bmp180-si7021-right.lua by pressing "Save to ESP" Nesting errors are detected at lines 18,19 and 38,39 relating to the bracketing around the %s in the middle of eac…
Jasea updated
8 years ago
-
Having a basic problem getting a fresh install of Sming to build. I followed the Windows setup guide, but when I open the eclipse examples, open the make targets, and run the "all", I get the followin…
-
Systematically powerDown() is not working for me (more precisely it returns a false)
powerUp() and other functions are working properly. The chip is a Winbond W25Q32BV
-
```
What steps will reproduce the problem?
1. See
http://aeroquad.com/showthread.php?1407-Floats&p=13784&viewfull=1#post13784
What is the expected output? What do you see instead?
Make sure that the…
-
```
What steps will reproduce the problem?
1. See
http://aeroquad.com/showthread.php?1407-Floats&p=13784&viewfull=1#post13784
What is the expected output? What do you see instead?
Make sure that the…
-
Hey lonelywolf,
I'm making some STM32F030 examples where i used your code.
Because you are using the STM32F1, and i am using the STM32F0 the code is very different.
But i'm using the BMP180 registers…