-
**Describe the bug**
On the web portal for the ESP, there are two sections, "I2C Settings" and "I2C Sensors", for which the "information" button does not lead to a valid sub-section of the page htt…
-
Hi, I'm usinng your library in various proyects, it's great !!
I'm trying to use it with the sensor that's came with Sonoff TH.
It's a board that include Si7021 sensor and some circuits to comunica…
-
It's could be an good idea !
Some tutorial to use [here](https://www.raspberrypi-spy.co.uk/2017/09/dht11-temperature-and-humidity-sensor-raspberry-pi/)
-
In Boot-Mode I can install the firmware.uf2 via drag and drop. After copying the file, it is possible to reach the rp2040 with Thonny and try some examples. After plug-off and plug.in the usb it is …
-
The ESP8266 returns 'nan' for temperature and humidity after flashing the device. Unplugging ESP power for a few seconds resolves the problem.
EDIT: Seems like a hardware issue on the DHT11 module
wzern updated
2 years ago
-
i have written a DHT11 thermometer class for version 2 microbits. it contains a dictionary of pin to bit id for example pin 0 uses bit 2. To create this dictionary I use a program in assembly to grab…
-
Add support for dht11 ou other alternatives
-
Hi i am trying to install 4 mic array as per given instructions but arecord -l does not show any device after installation
sudo ./install.sh
Hit:1 http://ports.ubuntu.com xenial InRelease
Hit:2 …
-
Hi is there some reason to drop decimal part of temerature for DHT11?
I modified the code to include it, and had parallel DHT11 and DHT22 connected,one next to the other, and then the temperature …
-
Hi! I have a 220V infrared heater in my cabinet. It is connected through a relay on my raspberry PI 4B gpio20 port. It is basically only an on/off heater. I have configured klipper to recognize it as …