-
Could someone please post some details pictures for how to connect the CH341A programmer with SOP8 chip to the MacBook Pro chip? I get "No EEPROM/flash device found." after using flashrom on MacOS.
…
-
Recently, some new timeout API methods were added to the AVR Wire library (see https://github.com/arduino/ArduinoCore-avr/issues/42#), which should be documented. Given there is no repository for the …
-
I tried uploading the ATMega328 code using ch340, and the error message occurred.
```
Arduino: 1.8.19 (Windows 7), Board: "ATmega328, Yes (UART0), EEPROM retained, Default, 328P / 328PA, BOD 2.7V…
-
I am trying to read the EEPROM for an ALfa AWUS036NHA wifi adapter.
The output of _lsusb_ is:
`Bus 001 Device 006: ID 0cf3:9271 Qualcomm Atheros Communications AR9271 802.11n`
I then try to ru…
-
I have a perfectly set up programmer (a shiny new [SerialUPDI](https://www.tindie.com/products/mcudude/serialupdi-programmer/) since you asked) that's connected to an AVR-Ex part.
If I mistype whic…
-
CheckPoint Safe@Office 1000n:
Quite similar just with slower 300MHz CPU and SFP connector but without WLAN. Discovered the same internal serial tty config as you did this morning (j14 jumper short,…
-
```
What steps will reproduce the problem?
1. install Android-x86 4.0-RC1 (Ics-x86) for eeepc on 701SD
2. ext3 and ext 2 same result
3. no Wifi, loop "tuning on wifi"
What is the expected output? Wha…
-
Hello,
I am not a programmer. I am trying to install qspectrumanalyzer on a Windows 7 machine. I installed PothosSDR-2017.05.02-vc14-x64.exe and QSpectrumAnalyzer-2.2.0-win-x64.msi. These programs…
-
I'm trying to run the install.sh on a Rpi4 4GB
…
-
Firstly well done on an excellent program. I have everything working superbly with my home built fluidNC controller. The only issue I have is when an alarm is triggered and the red flashing box appear…