-
Good morning
I am trying to port of octprint for the OrangePi Zero but I have some problems.
The steps I have followed have been a bit diverse. I started cloning the CustomPIOS repo but I realiz…
uNbAs updated
5 years ago
-
```
Build Configuration:
BB_VERSION = "1.42.0"
BUILD_SYS = "x86_64-linux"
NATIVELSBSTRING = "universal"
TARGET_SYS = "arm-poky-linux-gnueabi"
MACHINE …
-
Hi there, any ideas as to what is happening here?
Using a fresh "PI Zero - 256" I have compiled and uploaded U-Boot following the [Instructions for setting up SPI flash on Zero](http://www.orang…
-
Hi all,
I cannot build OrangePi Zero Plus2 (H5) image for Ubuntu Xenial:
+ chroot /home/war/OrangePi/OrangePiH5/output/rootfs mount -t proc proc /proc
chroot: failed to run command ‘mount’: Exe…
-
Hi all,
After the last updates does my scenes not work anymore. The ESP lights with Espurna turns off instead of On and the settings with OpenZWAVE are not made. In the log of the Espurna devices i…
-
Hi Arjan,
I’m Lighting/Show Designer, and I like to program my shows by my self. I’m always using a Hog4 lighting desk plus Reaper ( reaper.fm ) to play the sound track and generate timecode ( LTC…
-
Hi,
#### Description
I try to monitor my Orange Pi Zero running Ubuntu Core 16 with Glances.
I installed Glances in edge mode since stable channel isn't available for me.
``snap install glan…
-
Hi there,
I've just done a fresh git pull and I can't compile the firmware. I'm running makeall_firmware_h3.sh and end with this... any ideas?
```
hip@hip-Alienware-13:~/OrangePi/rpidmx512/scr…
-
Hi there
With the current bugfix version I experience lost steps on all axes with 8825 Stepper drivers
I tried the versions from June 16. and June 14.
The bugfix version from june 3. works fine
…
-
如果没有config.yml, 直接更新规则，会出现死循环
日志如图：
而且好像 如果不添加配置， 只要再进入 openclash的页面，就会一直死循环..除非…