-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…
-
```
In propgcc-0.2.2, the propeller-load.cfg does not contain definitions for the
Spin Stamp module from Parallax.
Because this module contains a 10MHz crystal, it is important to use the
correct t…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
What steps will reproduce the problem?
The lines:
"doc - This directory contains documents describing the
reference hardware, the tutorial
format, and…
-
```
demos/common/common.mk seems to default to bstc.osx. Created symlink as
workaround.
[root@Dell demos]# make
...
make[1]: Entering directory `/root/demos/TV/TvText_demo'
propeller-elf-gcc -Os -ml…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…