-
Found a problem with waking up the SX1261 chip.
In the sx1261mbxbas-board.c file of the void SX126xWakeup (void) function, you must add a delay of at least 100 μs after the ChipSelect signal.
`
voi…
-
**Summary:**
With the arrival of the node V0.1 PCB, we need to test the first prototype to ensure it is an acceptable prototype that can be used in the development of the device firmware.
The…
-
Hi,
I've been trying for a while now to run an AT Slave application using the SX1262, it works properly with the SX127x but with the SX1262 I can only transmit correctly.
Here is my hardware set…
-
I really like this idea.
Im building a testing one today here in Cape Town.!
Patrick
ZS1dBm
-
Hope I am not getting annoying with my issues.
I got my Insight DSP4520 modules. These modules combines a nRF52 and a SX1262 into one package.
Unfortunately on these boards the DIO2 is used as RF …
-
I said it before but again: Awesome Job and thanks for sharing the library with us!
## [Summary]
Using SX1262, Arduino Pro Nano if a second device that uses SPI added to the sketch, even after th…
-
Thank you for you library.
I was trying to use ESP8266 with EByte E22 900M22S module but I do not know how to connect pins of ESP8266 with this Lora module for simple receiver which after receiving…
-
The center frequency is out by enough to make communication fail with other vendor products that may be on the other side of the allowed oscillator tolerance.
-
-
I've written a firmware for an ESP32+SX1272 board. It does an OTAA once, then remembers the session keys in (simulated) EEPROM. On next boot/powerup, it starts in "ABP" mode with parameters from the O…