-
```
demos/common/common.mk seems to default to bstc.osx. Created symlink as
workaround.
[root@Dell demos]# make
...
make[1]: Entering directory `/root/demos/TV/TvText_demo'
propeller-elf-gcc -Os -ml…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
What steps will reproduce the problem?
1.Fresh load of 4.3 Beta
2.reboot
3.copy/paste fs.f
--------------
decimal \ last line of fs.f copy/paste
Prop0 Cog0 ok
Prop0 Cog0 ok
Prop0 Cog0 o…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…
-
```
A) What steps will reproduce the problem?
1. Create a new Spin project (or open an old one)
2. Compile project (compile works!)
3. Try to load the project to the EEPROM or to RAM
B) What i…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
```
I'd like to know what combination of
gcc toolchain (compile and objcopy, whatever
is needed)
produces a binary code that I can load with
ppropellersim and test
Can someone point me to a short h…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…