-
| SBC Name | Year | CPU | Core | Count | ISA |
| --- | --- | --- | --- | --- | --- |
| [Orange Pi Zero 2W](https://github.com/geerlingguy/sbc-reviews/issues/33) | 2023 | Allwinner H618 | Arm Cortex-…
-
CB1 eMMc on Manta M5P
I have setup the CB1 eMMc as a second MCU configured gpio79 for PI-FAN which is the socket on the M5P.
[mcu cb1]
serial: /tmp/klipper_host_mcu
[heater_fan SoC_fan]
pin: …
-
Hi, my esp32 is broken.. It had short on E0 thermistor pin to gnd. I thought that's problem of resistor issue or something on mainboard, but after a lot of measuring cicuts i know that's esp32 issue. …
-
Hi
I have the original probe (V2), wired to PE4 on the board. In your configuration.h there is the line: #define Z_MIN_PROBE_PIN PC15 // Pin 32 is the RAMPS default. The probe is not working, it does…
-
Hello, followed the instructions exactly, Voron starts up but motors do not move and message on LCD "Steppers OFF".
Is this a bug or a setting that needs to be updated in the config ??
Thank you…
-
Hi Biqu ,
Could you please share the source for this firmware ?
BIQU-B1/Firmware/2021-04-28/Motherboard-210428/Motherboard-SKR 2-210428/
Thank you
-
Since I try to recompile, but without success, can you guys put an SBC version of RRF firmware?
-
### Description
The FAN0 and FAN1 ports on the SKR Mini E3 V1.2 (and probably also the other revisions) are swapped, compared to the Creality Melzi 1.1.4 board found on the Ender 3 and 5.
In othe…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
When I start printing everything is fine for the first couple of layers. Then the print…
-
Just replaced a SKR Mini e3 V1.2 with a SKR Mini e3 v2.0, now BLTouch isn't working.
If I flip the Z-stop pins, black wire top and white bottom, the BLtouch lights up solid blue LED, no self test, …